How to remove the kitchen faucet and replace it with a new one? Precautions for replacing the kitchen faucet

How to remove the kitchen taps and replace it with a new one?

1. First, close the water door of the faucet at home. There is usually a water door next to the water meter. There is a small opening under some dishes. It is more convenient to use this small water door. Then reach under the sink and unscrew the fixing screw of the faucet. Usually, you can unscrew it by hand, after removing the old faucet, connect the two water inlet hoses to the faucet. At this time, the interface has long and short. It is said that this is for ease of installation. Install the short one first, and then install the long one.

2. Then screw the two water inlet hoses into the reserved holes of the sink, and fix the faucet with the nut below. The other end of the inlet hose is connected to the inlet pipe. If you are a hot and cold faucet, remember to distinguish it. Wrap waterproof tape and tighten with a wrench, open the water inlet valve, and check for water leaks.

Precautions for the replacement of the kitchen faucet

1. Some water inlet hoses are used for a long time, and the fasteners will rust or catalyze, causing the water inlet hose to be unscrewed. In this case, the oil drop can be placed on the rusty place, and then take out the basin faucet.

2. The single-hole faucet is a common kitchen sink faucets in many households. Pay attention to the basic fixation during installation. The mounting screws and nuts of the faucet must be fixed to prevent the faucet from loosening.

3. When installing a constant temperature water head, one thing to note is that the brass kitchen tap pipe is divided into cold water and hot water. During the installation process, it needs to be installed separately. Do not mix them, otherwise the tap will not drain. Also, don’t forget to install the hot and cold water filter.